Shown below are graphs of initial patterns of movement for exploring the Time state. Acceleration is used in both the positive and negative directions (shown by red and blue lines).
Parameters are given to explain how these patterns are created.
Example command:
python trajectoryWithTime.py [start_x] [start_vel] [acceleration] [num_waypoints] [hesitation]
These graphs show the position, velocity, and acceleration of the constant accelerating and decelerating patterns. Based on testing with the real robot rather than the simulator, I have eliminated all 0.1 m/s velocities because it appears to be below the robot's threshold for movement (to be looked into more thoroughly in the future). This includes the first and last waypoints for acceleration and deceleration, respectively.
Example commands:
acceleration: python trajectoryWithTime -16 0.2 0.1 10 F
deceleration: python trajectoryWithTime -16 1.0 -0.1 10 F
These graphs show the position, velocity, and acceleration of the paths that accelerate or decelerate after a hesitation. Again the waypoints at speeds less than 0.2 m/s were eliminated from the motion patterns. This includes the first and last waypoints for acceleration and deceleration, respectively as well as changing the velocity of the hesitation from it's original value of 0.05 to 0.2 m/s.
Example commands:
acceleration: python trajectoryWithTime -16 0.2 0.1 10 T
deceleration: python trajectoryWithTime -16 1.0 -0.1 10 T
Note: I have been switching between using 0.1 m/s (accel) + 1.0 m/s (decel) and 0.5 m/s for start velocities. In this case, start velocity is the velocity after the hesitation. It travels at 0.5 m/s to the point of hesitation in both conditions. This needs more work... not sure the best way to make these conditions comparable as acceleration and deceleration look very different after a hesitation.